Stanley-black-decker HD45 Instrukcja Użytkownika

1HD45HYDRAULICHAMMER DRILLSAFETY, OPERATION AND MAINTENANCE SERVICE MANUAL© The Stanley Works 2005SVCE/MAINT USAPrinted in U.S.A.05436 8/2005 ver 2S

10OPERATIONPREOPERATION PROCEDURESCHECK POWER SOURCE1. Using a calibrated fl owmeter and pressure gauge, check that the hydraulic power source develops

116. If the bit binds in the hole, reverse direction of the bit rotation to assist in “backing out” the drill.7. Keep the drill bit centered in the ho

12NOTE: It may be necessary to set the gauge at 650-700 psi/45-48 bar to overcome any pressure drop through the charg-ing system.4. Open the valve on

13CHARGING THE ACCUMULATOR

14TOOL EQUIPMENT & CARE• Make sure all couplers are wiped clean before connection.• The hydraulic circuit control valve must be in the “OFF” pos

15TROUBLESHOOTINGPROBLEM CAUSE SOLUTIONDrill does not run.Power unit not functioningCheck power unit for proper fl ow and pressure (7-9 gpm/26-34 lpm,

16SPECIFICATIONSOperating Pressure ...

17SERVICEGood maintenance practice keeps the drill on the job and increases its service life.The most important maintenance practice is to keep the hy

185. To remove the fl ow sleeve from the fl ow sleeve tube, re-move the automatic valve body and associated parts from within the fl ow sleeve removal tu

19SERVICE3. Place the motor plate on an aluminum plate latch end up in an arbor press.4. Install latch parts with Latch Installation Tools (part num-b

2

20SERVICE7. Install the porting block into the end of the automatic valve body with proper roll pin alignment.8. Place the fl ow sleeve assembly in a b

21HD45 PARTS ILLUSTRATION

22HD45 PARTS LISTItem No.Part No. Qty Description1 04369 1 Handle2 04371 1 Trigger3 04077 1 Valve Spool, OC04593 1 Valve Spool, CC4 01650 1 Charging V

23Stanley Hydraulic Tools (hereinafter called “Stanley”), subject to the exceptions contained below, warrants new hydraulic tools for a period of one

Stanley Hydraulic Tools3810 SE Naef RoadMilwaukie, Oregon503-659-5660 / Fax 503-652-1780www.stanley-hydraulic-tools.com

3For the nearest authorized and certifi ed dealer, call Stanley Hydraulic Tools at the number listed on the back of this manual and ask for a Customer

4CERTIFICATE OF CONFORMITY ÜBEREINSTIMMUNGS-ZERTIFIKATCERTIFICAT DE CONFORMITE CEECERTIFICADO DE CONFORMIDADCERTIFICATO DI CONFORMITA

5Safety symbols and signal words, as shown below, are used to emphasize all operator, maintenance and repair actions which, if not strictly followed,

6SAFETY PRECAUTIONSRead the ManualWear EyeProtectionWear EarProtectionWear Dust MaskTo avoid serious injury or death 47351Tool operators and maintenan

7The safety tag (p/n 15875) at right is attached to the tool when shipped from the factory. Read and understand the safety instructions listed on thi

8 HOSE TYPESHydraulic hose types authorized for use with Stanley Hydraulic Tools are as follows:  Certifi ed non-conductive  Wire-braided (conduct

9HTMA REQUIREMENTSFLOW RATETOOL OPERATING PRESSURE(at the power supply outlet)SYSTEM RELIEF VALVE SETTING(at the power supply outlet)MAXIMUM BACK PRES